GreenWorks GPW 1951 Manual Del Operador página 24

PROBLEM
Detergent is not coming
out.
Garden hose connection
leaks.
Spray wand, extension, or
spray tip leaks.
Pump is noisy.
Water leaks from pump.
Oil is dripping.
Soap does not come
out or comes out at low
pressure.
TROUBLESHOOTING
POSSIBLE CAUSE
Detergent is too thick.
Filter on detergent
suction tube is
clogged.
Damaged or clogged
detergent suction
tube.
Spray tip is
obstructed.
Loose connection.
Missing/worn rubber
washer.
Broken o-ring or
plastic insert.
Pump is sucking air.
Water filter is clogged.
Loose fittings.
Water seals are
damaged or worn.
Oil seals are damaged
or worn.
75 degree tip / Soap
Tip (Black color) is not
installed in wand.
Soap tank may be
plugged with debris or
thick soap.
EN - 24
SOLUTION
Dilute detergent.
Run warm water through filter to remove build-
up.
Remove obstruction or replace detergent
suction tube.
Blow out or remove debris with a fine needle.
Tighten connection.
Insert new washer.
Call the Toll-Free Helpline.
Check that hoses and fittings are airtight. Turn
off machine and purge pump by squeezing
trigger gun until a steady flow of water emerges
through the spray tip.
Remove water filter and rinse in warm water.
Check that all fittings are tight.
Call the Toll-Free Helpline.
Call the Toll-Free Helpline.
Install 75degree, black, soap tip in wand.
Empty soap from tank, clean out using vinegar
and water.