Operating The Dryer - Kenmore 402.8903 Serie Manual De Uso Y Cuidado

OPERATING THE DRYER
1. LOAD THE DRYER
Load the dryer with the wet laundry from the washer. If the
load is extra large, you may need to divide it into smaller loads
for proper performance and fabric care.
2. CLEAN THE LINT FILTER
If the lint filter has not already been cleaned, lift out the filter and
remove the lint from the last load. This will help ensure the fastest
and most efficient drying performance.
Pow@w'
c_ k
Dry odr,g Wr _=k,*_a_d
xl_ Dly _ 60
Damp 30
Timed DL'y
Touch Up
Express Dry
3. TURN ON THE DRYER
Press the POWER button to turn on the dryer. The cycle LEDs
will illuminate and a chime will sound, if turned on.
Refer to page 18.
4. SELECT A CYCLE
Turn the Cycle Selector Knob either direction until the LED for the
desired cycle is on. The preset temperature, dryness level, and
option settings for that cycle will be shown.
Refer to page 20.
5. SELECT CYCLE MODIFIERS
Default settings for the selected cycle can now be changed if
desired. This can be done using the cycle modifier buttons as
shown on page 23 (temperature, dryness level, and chime).
NOTE: Not all options or modifiers are available on all cycles.
6. SELECT CYCLE OPTIONS
Cycle options can be added using the options buttons as shown
on page 24 (wrinkle guard and control lock).
NOTE: Not all options or modifiers are available on all cycles.
7. BEGIN CYCLE
Press the START/PAUSE button to begin the cycle.
The cycle can be paused at any time either by opening the door
or by pressing the START/PAUSE button.
WrinM÷ Guard
8. END OF CYCLE
When the cycle is finished, the chime will sound if it is set.
Remove your clothing from the dryer immediately to reduce
wrinkling. If Wrinkle Guard is selected, the dryer will tumble briefly
every few minutes to help prevent wrinkles from setting in the
clothes.
19
KemnoreDi?erOwnersMamml-01 EN.indd 19 2010-06-17 _73:33:51