Periodic Brake Test For Mechanical Brakes; Air Intake And Cooling Fins; Rear Axle; Checking The Lubricant Level - E-Z-GO REFRESHER 1200 Manual Del Propietario Y Guia De Servicio

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
The Periodic Brake Performance Test should be per-
formed regularly as an evaluation of braking system per-
formance. It is useful as a method of identifying subtle
loss of performance over time.

Periodic Brake Test For Mechanical Brakes

The purpose of this test is to compare the braking perfor-
mance of the vehicle to the braking performance of new
or 'known to be good' vehicles or to an established
acceptable stopping distance. Actual stopping distances
will be influenced by weather conditions, terrain, road
surface condition, actual vehicle weight (accessories
installed) and vehicle speed. No specific braking distance
can be reliably specified. The test is conducted by latch-
ing the park brake to eliminate different pedal pressures
and to include the affects of linkage mis-adjustment.
Establish the acceptable stopping distance by testing a
new or 'known to be good' vehicle and recording the
stopping location or stopping distance. For fleets of vehi-
cles, several vehicles should be tested when new and
the range of stopping locations or distances recorded.
Over time, a subtle loss of performance may take place; there-
fore, it is important to establish the standard with a new vehicle.
Drive the vehicle at maximum speed on a flat, dry, clean,
paved surface (Ref Fig. 33 on page 24). Quickly depress
the brake pedal to latch the parking brake at the line or
marker in the test area and remove foot from pedal. The
vehicle should stop aggressively. The wheel brakes may
or may not lock. Observe the vehicle stopping location or
measure the vehicle stopping distance from the point at
which the brakes were latched. The vehicle should stop
within the 'normal' range of stopping distances. If the
vehicle stops more than 4 ft. (1.2 m) beyond the accept-
able stopping distance or pulls to one side, the vehicle
has failed the test and should be tested again.
If the vehicle fails the second test, it should immediately
be removed from service. The vehicle must be inspected
by a qualified mechanic who should refer to the TROU-
BLESHOOTING section in the Technician's Repair and
Service Manual.
OPERATION AND SERVICE INFORMATION

AIR INTAKE AND COOLING FINS

To prevent possible burns, engine parts
should be kept clean to reduce risk of over-
heating and ignition of accumulated debris.
After every off road use, allow to cool and
then check for a build up of dirt and debris
in the air intake and cooling fins. Dirt and
debris may clog the engine's air cooling
system. Clean areas shown to prevent
engine damage. Keep linkages, springs and
controls clean. Keep area around muffler
free of any combustible material.
At least once a year, or more often under adverse condi-
tions) the cooling system should be cleaned. Cleaning
will assure an adequate supply of air to the cooling fins.
Compressed air may be used for routine cooling system
maintenance.

REAR AXLE

The rear axle is provided with a lubricant level check plug
located on the driver side at the rear of the housing (Ref
Fig. 35 on page 26). Unless leakage of rear axle lubricant
is evident, an annual lubricant check is sufficient.

Checking The Lubricant Level

Tool List
Socket, 13 mm, 3/8" drive ........................................... 1
Owner's Manual and Service Guide
Fig. 34 Cleaning Cooling System with Air
Qty. Required
Page 25