3M Versaflo TR-659 Instrucciones De Uso página 6

6. Attach the Breathe Easy™ Power Cord or GVP 610 power cord to the adapter (Fig. 5). For the GVP, plug socket end of the power cord into the
prong receptacle on the front of the GVP-100 motor/blower. Power the motor/blower on by holding the power button on the adapter down for 1/2
second. When powered on, the indicator light on the TR-659 should blink for approximately one second and then turn off.
7. With the power cord securely connected and the motor/blower running, re-position the top flap of the holster over the adapter and battery and
secure snaps in place. To do this, you will need to crisscross either side of the top flaps (Fig. 6). Make sure adapter indicator light can be seen
through clear window on top of holster (Fig. 7).
To power the motor/blower off, hold the power button on the adapter down for 3 seconds. When there is approximately 15 minutes of charge left on
the TR-630 battery pack, the LED indicator light on the adapter will begin blinking. Immediately exit the contaminated area when the visual alarm
(LED indicator light) on the adapter activates.
To detach the TR-630 battery from the TR-659 battery adapter, engage the blue release tab on the battery and lift out (Fig. 8).
When used with the TR-656 Heavy Duty Holster
1. Connect the TR-630 battery to the TR-659 adapter as shown (Fig. 8).
Inserting the 3M™ Adapter TR-659 with battery into Heavy Duty Holster TR-656
2. If not already done, unbutton the clip holding the top flap of TR-656 heavy duty holster in place. Fold top flap of the holster back so it is ready to
accept the adapter and battery.
Fig. 5
Fig. 6
Fig. 8
Fig. 7
5
(English)