Harbor Breeze 00873 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1. Attach mounting plate (A) to outlet box (not included)
using two screws (not included). Securely tighten two
outlet box screws. Pull black, white, and grounded
wires out of outlet box and through the hole in the
mounting plate (A).
2. Place trim ring (C) over canopy, and lay it on fan
motor (B).
3. Loosen two preassembled screws across from each
other on the mounting plate (A). Remove and save
remaining two preassembled screws. Hang fan motor (B)
on mounting plate (A) hook using one of the non-slotted
holes in the canopy.
1
Outlet box
Screw
2
Canopy
B
3
Screw
Hook
Canopy
B
Lowes.com/harborbreeze
6
ASSEMBLY INSTRUCTIONS
4. Connect BLACK wire from fan to BLACK wire from
ceiling. Connect WHITE wire from fan WHITE wire
from ceiling. Connect all GROUNDED (GREEN) wires
together from fan GREEN/GROUNDED wire from ceiling.
Connecting the GREEN/GROUNDED wires is conducive
to receive the signal of the remote control.
Note: Black wire is hot power for fan and light kit. White
wire is common for fan and light kit. Green wire is
grounded wire. lf house wires are different colors
than referred to above, stop immediately and consult a
professional electrician to determine proper wiring.
A
5. Twist wire ends together and screw wire connectors (AA)
on in a clockwise direction. Tape wire connectors (AA)
C
and wires together.
Note: Wires should be spread apart with grounded
conductor and equipment-grounding conductor on one
side of outlet box and ungrounded conductor on other
side. After making connections, make sure bare wire
or wire strands are NOT visible. Place green and white
connections on opposite side of box from black and
blue connections. Splices should be turned upward and
pushed carefully up into outlet box.
Hardware Used
AA
Wire Connector
6. Align keyholes on fan motor (B) with protruding screw
heads on mounting plate (A). Lift fan motor (B) up to
A mounting plate (A), making sure not to break any wire
connection. Rotate clockwise until screw heads fully
engage into keyholes. Insert previously removed screws
(Step 3, page 6) and securely tighten all screws.
B
4
Grounded/
Green
White
Black
5
AA
x 4
6
A
Lowes.com/harborbreeze
7
Supply circuit
outlet box Outlet box
Green/ GREEN/
Grounded
GROUNDED
Receiver receiver
Screw
B