Assembly Instructions; Operating Instructions - Harbor Breeze 00873 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS

13.
CAUTION: Avoid touching the bulb with bare hands. Be
sure that the power is OFF and bulb is cool before
OPTIONAL:
14. If desired, wall bracket (M) can be installed to house
remote control (K). Remove small plate preassembled
on the wall bracket (M) and use remote control screws
(CC) to install wall bracket (M) to wall. Replace the
small plate, then place remote contral (K) into the wall
bracket (M).
Hardware Used
Remote Control Screw
CC
13
Raised
dimples
Flat area
J
J
14
K
Small plate
x 2
M
CC
Lowes.com/harborbreeze
10

OPERATING INSTRUCTIONS

REMOTE CONTROL TRANSMITTER:
Note: The receiver is already wired and built into the fan canopy from the factory. Receiver assembly is not
needed. "Tap" refers to pressing a button on the remote for less than one second. "Press and hold" refers to
pressing a button and holding the button down for one second then release the button.
After fan installation is completed properly and power is turned on, the fan receiver will produce two
musical notes/sounds indicating that the power supply is normal. If no sounds are heard, please refer to
TROUBLESHOOTING section on page 14.
1. Install Battery:
I
G
Remove the battery cover from the remote control (K), and install
the battery (L). Replace the cover.
2. Learning/Pairing (See Fig. 1):
The dip switch in the remote control (K) has been set to "0" to match
the receiver in the fan. If there is more than one remote control in a
room, changing dip switch settings may be needed.
To change a dip switch setting, slide the switch inside the battery
compartment to "1", turn off power to the fan, then turn on the power.
The fan receiver should make two musical notes/sounds indicating that the power supply is normal. Within
30 seconds of hearing notes/sounds, tap the "learn" key on the back of the remote control (K). If learning
is successful, the fan light will blink three times and turn on. Note: The fan will run at the highest speed in
corresponding direction per seasonal slide switch.
3. Season Slide Switch:
When the season changes, you may want to change the direction your fan spins. To switch between
Note: Wait for fan to stop before reversing switch.
• In warmer weather, counterclockwise rotation creates a downward
icon. Receiver will make 3 musical sounds.
which moves hot air from the ceiling into the room. Push the switch
sounds.
1
Dip switches
12V
K
Open the battery
housing cover.
2
6 Speeds
Fan on/off
Natural Breeze
Home Shield
Season Slide
Sleep Timer
Switch
R
K
Lowes.com/harborbreeze
11
Learn key
L
Light On/Off
/Dimming
Walk Away
Light Delay

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

0087400875046446704644680464469

Tabla de contenido