Harbor Breeze 40093 Manual De Instrucciones página 10

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
3. Slide the downrod (A) into the yoke of the motor
assembly (F), align the holes, and re-install the
downrod clip (DD) and downrod pin (EE). Then
tighten the motor housing set screws (FF).
Haodwaoe Used
DD Downrod Clip
EE
Downrod Pin
Motor Housing
FF
Set Screw
4. Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested that you do so in the following manner:
Take the lead wires and make sure that you have
pulled them all the way through the top of the
downrod and measure 8 in. of lead wire, and then cut
the excess wire off with wire cutters.
3
DD
x 1
x 1
x 2
4
10
A
EE
FF
Lowes.com/harborbreeze
F