Harbor Breeze 40093 Manual De Instrucciones página 8

INITIAL INSTALLATION
4. Remove the two mounting bracket screws (HH) from
the round holes of the canopy (C). Set aside for later
use. Detach mounting bracket (D) from canopy (C).
Secure the mounting bracket (D) to the outlet box
(not included) using screws and washers provided
with the outlet box.

Note: It is very important you use the proper
hardware when installing the mounting bracket
(D) as this will support the fan.
Impootaat:

If using the angle mount, ensure the
open end of the mounting bracket (D) is installed
facing the higher point of the ceiling.
Haodwaoe Used
Mounting
HH
Bracket Screw
5. Remove the motor screws (AA) from the underside of
the motor assembly (F).
Note:
If there are plastic motor blocks installed,
discard them but keep the motor screws (AA).
For Staadaod oo Aagle Mouatiag Iastouctioas,
continue to page 9. For Closemouat Iastouctioas,
proceed to page 12.
Haodwaoe Used
AA
Motor Screw
4
C
x 2
5
x 10
8
D
D
Motor Block
Lowes.com/harborbreeze
HH
AA
F