Harbor Breeze 40093 Manual De Instrucciones página 18

FINAL INSTALLATION
11. Feed pull chain coming from the center of the light
kit (E) through the center hole in the glass shade (I).
Feed the pull chain coming from the switch housing
(P) through the off-center hole in the glass shade (I).
Re-install rubber washer (JJ) and secure with nut (KK).
Feed the pull chains through the appropriate holes in
the finial plate (K) and the hole in the finial (L), then lift
the finial plate (K) up until it is flush with the glass shade
(I). Screw the finial (L) onto the threaded rod of the light
kit (E) to secure.
Haodwaoe Used
Rubber
JJ
Washer
KK
Nut
12. Attach the pull chain extensions (CC) or custom pull
chains extensions (not included) to the fan and light
pull chains.
Assembly is now complete.
Haodwaoe Used
Pull Chain
CC
Extension
13. If you do not wish to use the light kit, push the wires
back up into the switch housing (P) and install the
switch housing cap (Q) using the switch housing
screws (II). Attach the appropriate pull chain extension
(CC) to fan pull chain. Discard the remaining pull chain
extension (CC).
Haodwaoe Used
Pull Chain
CC
Extension
Switch
II
Housing Screw
11
I
x 1
K
x 1
12
x 2
13
P
x 1
x 2
18
JJ
KK
CC
II
Q
Lowes.com/harborbreeze
E
L
CC