Installation - ATON AVC100SL Manual Del Usuario

Installation

With the rough-in box installed and speaker wires pulled to the location,
installation can commence. Make wiring connections first, then mount the
Volume Control in the wall.
1. Disconnect amplifier from electricity before starting.
2. Secure colored faceplate to Volume Control, push knob in place
(AVC100R). Secure mounting plate to the VC, noting 'TOP' orientation,
with the supplied (2) phillips screws.
3. Strip back 1/4" of the insulation from the end of the speaker wires.
4. Twist bare wires tightly making sure their are no frayed wires.
5. Secure each wire from the amplifier to its respective connector. Use
screw terminals to tighten.
L+ to L+, L- to L-, R+ to R+, R- to R
6. Next, make connections to the speakers using the same
L +/-, R +/- scheme.
7. Carefully place the Volume Control in the rough-in box making sure not
to put strain on the speaker / amplifier connections.
8. Insert two 1" screws into the mounting holes of the AVC100SL /
AVC100R to mount the unit into the rough-in box. Tighten these screws
until the unit is at the proper depth to mount flush with the wall.
9. Place Decora cover, noting TOP orientation, at top of faceplate insert
tab. Swing down bottom and snap into place.
©ATON 2010 • All rights reserved.
VOLUME CONTROL INSTALLATION MANUAL
Page 9