Tabla de contenido
Publicidad
VOLUME CONTROL INSTALLATION MANUAL
10. Connect speaker wires to amplifier. Make sureproper polarity is main-
tained or sound quality will suffer.
11. Connect amplifier to power and test.
DO NOT CONNECT THE WIRES FROM THE VOLUME
CONTROL TO THE AMPLIFIER UNTIL THE FOLLOWING
CHECKS HAVE BEEN PEFORMED!
Checking the Installation
1. With an Ohm meter, measure the resistance between the + and - of
each pair of wires that is to be connected to the amplifier's speaker
outputs. Under no circumstances should this reading be below the
amplifier's minimum impedance. A reading of less than 4 Ohms may
mean that the Input and Output plugs on the Volume Control have been
hooked up backwards (potentially causing damage to the amplifier). An
open reading may indicate a polarity reversal.
2. Make sure amplifier is not powered up whenmaking connections or
testing.
DO NOT REVERSE THE AMPLIFIER INPUT AND
SPEAKER OUTPUT CONNECTIONS! THIS CAN RESULT
IN DAMAGE TO EQUIPMENT AND/OR PROPERTY.
Page 10
© ATON 2010 • All rights reserved.
Publicidad
Tabla de contenido
