Tabla de contenido
Publicidad
VOLUME CONTROL INSTALLATION MANUAL
Troubleshooting
Symptom
Possible Cause
No audio present
1. Source not
playing
2. Volume turned all
the way down
3. Amplifier/
Speaker con-
nectors reversed
4. Speakers in
room miswired or
defective.
Poor audio
1. Clipping or
quality
distortion
2. Speakers out of
phase
3.Incorrect Imped-
ance Match settings
4. Incorrect assign-
ment of left/right
source RCA cables or
speaker cables
Page 12
Solution
Press Play, turn ON etc.
Increase volume
Check and correct con-
nections
a. Test speaker at back of
amplifier
b.Verify connections
Reduce Receiver/Ampli-
fier level
Carefully check polarity of
each speaker
See Imp. Match Section
starting on pg.8 and set
switches correctly
Isolate to source or room
and correct
© ATON 2010 • All rights reserved.
Publicidad
Tabla de contenido
