Terminal Cover; Badge; Bfc (Beat Frequency Control) Switch; Power Indicator - Pioneer PRS-A900 El Manual Del Propietario

Terminal Cover

Before setting up the unit, unfasten the screws with a 4 mm hexagonal
wrench and remove the terminal cover.

Badge

When you change the BFC switch or the direction of the badge, unfasten
the screws with a 2 mm hexagonal wrench and remove the badge. Be
careful not to lose the screws when fastening and removing.

BFC (Beat Frequency Control) Switch

If you hear a beat while listening to an AM broadcast with your car
stereo, change the BFC switch using a small standard tip screwdriver.

Power Indicator

The power indicator lights when the power is switched on.

Input Select Switch

For two-channel input, slide this switch to the left. For four-channel
input, slide this switch to the right.

Gain Control

Adjusting the gain controls A and B will help match the output of the car stereo to the
Pioneer amplifier. Normally, set the gain controls to the NORMAL position. If the output is
low, even when the volume of the car stereo is turned up, turn these controls clockwise. If
there is distortion when the volume of the car stereo is turned up, turn these controls
counter-clockwise.
• If you only use one input plug, set the gain controls for speaker outputs A and B to the same posi-
tion.
• When using with an RCA equipped car stereo (standard output of 500 mV), set to the NORMAL
position. When using with an RCA equipped Pioneer car stereo with max. output of 4 V or more,
adjust level to match the car stereo output level.
4