ENGlish
Table of contents
5.0 Use ..................................................................16
7.0 Service .............................................................19
Figures ................................................................. 50
14
1.0 Relationship to the
authorities
Installation of a fireplace must be according to local codes and
regulations in each country.
All local regulations, including those that refer to national and
European standards, shall be complied with when installing the
product.
Instructions for mounting, installation and use are enclosed with
the product. Prior to using the product the installation must be
inspected by a qualified person.
A product data label in heat resistant material can be found on the
heat shield underneath the product. This contains information
about identification and documentation for the product.
2.0 Technical data
Material:
Finish:
Fuel:
Log length, max:
Flue outlet:
Flue pipe dimension:
Approx. weight:
Optional extras:
Dimensions, distances:
Technical data according to EN 13240
Nominal heat output:
Flue gas mass flow:
Recommended chimney draught:
Efficiency:
CO emission (13% O
):
2
Flue gas temperature:
Operational type:
Cast iron
Black paint
Wood
40 cm
Top, rear
Ø 175 mm, 240 cm
cross section
2
106 kg
Decorative enamelled floor
plate in blue black - Rear heat
shield, short legs* (see 8.0)
See fig. 1
6,5 kW
4,8 g/sec
12 Pa
79%@7,4kW
0,30%
330
C
o
Intermittent