Guidelines For Operation; External Power Supply; Battery Installation - Pulsar CORE FXQ35 Manual Del Usario

6

GUIDELINES FOR OPERATION

The unit has been designed for long-term use. To ensure sustainable
performance, please adhere to the following:
Before use make sure that you have mounted and adjusted the unit
џ
according to the instructions of the section marked Operation.
Store in the carrying case with the lens cap on.
џ
Switch the device off after use.
џ
Any attempt to dismantle or repair the device will void the warranty!
џ
The device is designed for use in a wide range of operating temperatures.
џ
However, if it has been brought indoors from cold temperatures, do not turn it
on for 2 to 3 hours. This will prevent condensation on the external optical
surfaces.
To ensure reliable performance, regular technical inspections of the device
џ
are recommended.
WARNING! Do not point the objective lens of the device at intense light
sources such as the sun. This may cause electronic components in the device
to malfunction. The warranty does not cover damage caused by improper
operation.
7

BATTERY INSTALLATION

џ
џ Turn the battery compartment knob (3) counter-clockwise
as far as it will go and remove it.
Install two CR123A batteries observing the correct
џ
polarity as shown on and inside the battery cover.
Replace the battery cover and press it until it clicks -
џ
make sure the cover is closed on both sides.
Charge level appears in the status bar (
џ
When the battery is completely discharged, this
џ
icon flashes in the status bar.
џ
Warning: do not use rechargeable batteries since their use
causes inaccurate battery level indication and possible
disconnection during operation.
Note: do not use batteries of different types or batteries with various levels of
charge.
6
Open:
).
Pic. 2
8

EXTERNAL POWER SUPPLY

The supplied external power adapter allows you to use the following as
external power supply:
- power bank (output voltage 5V, USB plug) or
- EPS3I or EPS5 Battery Pack (output voltage 12V; 2.1 mm plug).
How to connect:
Open and remove the battery compartment cover (see section 7).
Install the external power adapter into the monocular's battery
compartment (see Fig. 3) and press it firmly from above to make sure
that the adapter's latches (C) have snapped on both sides.
Secure the cover (6) on the adapter (see Fig. 3).
Connect your power bank to the USB port (5V) or your EPS3I/EPS5
battery Pack to the external power jack (12V).
Power the unit on with a short press of the "ON/OFF" (9) button.
To remove the external power adapter, push the latches on both sides
and pull it.
Note. When using your own external power supply, central pin of the 12V
power supply that you connect to the "power" jack of the unit, must have
marking "+".
The power supply or the plug may have marking
Warning! When the unit operates on external power supply, the low
battery indicator (icon ) does not show the actual battery charge level.
3
5V
C
12V
Fig. 3
7