Beta 960KI Instrucciones página 11

INSTRUCTIONS FOR USE
• Here at the side are shown the configurations which
are possible using the feet
the type of screws (hexagonal or cylindrical head with
hexagon socket) located on the engine head (fig. 12).
• Place the washer with bearing
E
• Tighten the screw and adjust its height using the
G
nut (fig. 13).
For problems of height select the type of
extension S or T
adapter used.
• Here at the side are shown the configurations which
are possible using the extension
Configurations:
N - O
1
For adapters
2
M
For adapters
3 M
For adapters with deeper injectors.
4 N - O
For adapters
with deeper injectors.
E
• Tighten the screw (or extension if used) to the
adapter already fastened to the injector and make sure
that the plane of the crosshead
the axis of the screw.
G
• By tightening the nut
must rest perfectly on the crosshead
adjust the support feet on the cylinder head screws.
• The fine adjustment of height is performed by rotating
the threaded part of the support foot
• After adjusting the structure and locked the 6 screws
proceed with the extraction of the injector
G
by screwing the nut
(fig. 15).
• For the extraction of the injector it is possible to
use the hydromechanical cylinder
K
washer with bearing .
• Even in this case ensure that the base of the cylinder
leans perfectly on the crosshead (fig. 16).
Always place the lower supports
vicinity of the injector and never far away, so
as to ensure more rigidity to the structure and
maintain the concentricity during the extraction
phase.
J H
and according to
K
on the crosshead
depending on the type of
S T
or (fig. 14).
- P - Q - R
- P - Q - R
L
is perpendicular to
the washer with bearing
L
, otherwise
D
.
keeping locked the screw
B
instead of the
I
in the
12
L
.
13
14
15
K
16
E
17
EN
11