Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
• Example of fastening to the head (4 feet) with
mechanical extraction (fig. 18).
• Example of fastening to the head (4 feet) with
hydraulic extraction (fig. 19).
ASEMBLY OPTION 2:
SUPPORT WITH 3 FEET WITH A CROSSHEAD
D
• Connect 3 feet
to the crosshead
C
support plates
(fig. 20).
• In the case of large differences in height, it is possible
to use the support foot extension group
the extension for the adjustable foot
The fine adjustment of height is performed by rotating
the threaded part of the support foot
• Position and align the removal tool on the head. Place
the washer with bearing
• Tighten the screw
• For problems of height select the type of extension
T
or
depending on the type of adapter used.
• After adjusting the structure and locked the 3 screws
proceed with the extraction of the injector by screwing
G
the nut
keeping locked the screw
• It is possible to place on the crosshead
E
extraction screws
B
cylinder
in place of the washer with bearing
• Example of fastening to the head (3 feet) with hydro
and mechanical extraction (fig. 23).
12
L
with screws and
H
(fig. 21) or
J
.
D
.
K
L
on the crosshead
E
and adjust its height using the nut
E
.
L
both
or use the hydromechanical
18
19
.
G
.
S
20
K
.
21
22
23
EN
Publicidad
