Assembly; Setting Up The Tripod - Celestron TRAVEL SCOPE 80 Manual De Instrucciones

ASSEMBLY

Set up your Travel Scope indoors the first time and familiarize yourself with the correct assembly procedure before
attempting it outdoors .

SETTING UP THE TRIPOD

1 The tripod comes preassembled . Stand the tripod upright and
pull the tripod legs outward until each leg is fully extended .
2 To raise the height of the tripod, unlock the tripod leg lock
clamps at the bottom of each tripod leg by opening the clamp
for each section and pulling outward . Once a clamp is unlocked,
pull the tripod leg out as far as it will go, and then close the
leg lock to secure it . Continue doing this for each tripod leg
and each section to raise the height to the level you desire .
3 If you want to raise the tripod height up further, use the central
column locking knob . Turn the locking knob counterclockwise
until loose . Then, pull up on the head of the tripod . Continue
pulling to the height you desire and then tighten the locking
knob . To ensure the stability of the mount, make sure the column
extension knob is tight .
6 I ENGLISH