Kohler K-1737 Guia De Instalacion página 9

Steam Adapter
Remove adhesive backing.
Back View
Steam
Generator
5. Install the Steam Adapter
Remove the adhesive backing from the back of the steam adapter.
Mount the steam adapter firmly to the side panel of the steam generator.
NOTICE: Do not pinch, nail, wedge, or use undue force when handling the RJ12 connector cable. Any
damage may result in adapter kit failure. If the steam adapter kit is not installed immediately, protect the
control cable end with tape or other shielding material.
Carefully plug the RJ-12 cable into the steam adapter and the steam generator.
Connect the temperature sensor wire to the corresponding port on the steam adapter.
Route the media module cable from the steam adapter to the media module (or peripheral
equipment) and connect at both ends. Refer to and follow the instructions packed with those
devices.
The terminator is factory installed and must remain installed if no additional equipment is to be
added in series to this device. If additional equipment is to be connected downstream of this device,
remove the terminator and follow the instructions packed with the additional equipment.
Restore the power at the main breaker panel.
Turn on both water and power to the generator.
Kohler Co.
RJ-12 Cable
Install terminator
or connect to
peripheral device.
9
To Steam Sensor
Temperature
Sensor Cable
To Media
Module
1069332-2-B