Powering On And Off - Zagg Slim Book Instrucciones

INSERTING/REMOVING YOUR TABLET
To insert your tablet into the Slim Book, open the Book's
case and remove it from the keyboard (to do this, pull
the case up and away from the keyboard). Then, line
up your tablet with the holes in the case. Make sure the
camera hole is aligned properly as well as the opening
for the cable. When everything is aligned, set the bottom
half of your tablet in the cover and apply light pressure
to ensure it is properly settled. Snap the top half of your
tablet into the cover. Check all corners to make sure they
have seated properly.
When your tablet is secure in the case, you can connect
it to the keyboard by placing it in the magnetic trough.
Powerful magnets will secure it in place, but also allow
you to remove your tablet any time it benefits you.
To easily remove your tablet from the case, separate the
case from the keyboard, and then gently pull the case
away from the edges while pressing the tablet from
behind. Grasp your tablet's exposed side and lift/pull
away from the Slim Book.

POWERING ON AND OFF

To turn your Slim Book on, press the Power button. A green
LED will illuminate briefly while the keyboard powers up. To
turn your Slim Book off, press and hold the
Power button for three seconds. A red LED
will flash, indicating your Slim Book has
turned off.
1