Tiiwee X4 Manual Del Usuario página 10

Open the back panel to insert the ba eries. Please respect the correct polarity.
Now, close the back panel again. Slide the ball joint in place un l it locks in
place. Then, a ach the wall mount on the ball joint. Your PIR sensor is now
ready to be installed on the mount.
General installa on guidelines
Avoid posi ons close to a window, air condi oners, fluorescent lights, heaters,
refrigerators, stoves, and direct sunlight and other places where the
temperature would change rapidly, and air flow is high. If there are two
detectors in the same detec ng range, please adjust the posi on to avoid
interference and false alarms.
A ach the detector to the bracket, and change the detec ng angle and distance
by adjus ng the installa on height and the bracket. It is advised to install the
device at a height of approximately 2 meters.
IMPORTANT: The Infrared detector is sensi ve to a human's horizontal movement.
The detector is less suscep ble to ver cal movements. Therefore, it is advised
to aim the device at a 90 degrees' angle to a person's walking direc on.
How to mount a PIR mo on sensor
Unlike magne c door and window sensors, PIR mo on sensors recognize heat
differences. Some mes heat differences are unno ceable. Our PIR mo on
sensors feature advanced algorithms that help to detect the difference
between a human being and environmental heat changes. However, it is
essen al to carefully select the right posi on of PIR mo on sensors for it to
properly func on. Here are a few recommenda ons:
Therefore, we recommend installing the mo on detector in a corner that is void
from any of those factors men oned above, and where the sensor looks into
the room you want to guard.
Test
1. A er the installa on, turn the switch to ON. Now, walk or move in front of
the PIR sensor at a distance between 3 and 6 meters.
16
2. The Indicator light should light up once. Note the 5 seconds delay between 2
signals. The delay is normal and inten onal to save ba ery power.
3. If needed, adjust the detector angle to get the desired detec on range.
When the detector indicator flashes
LED flashes once: A signal is detected, and the detector sends a signal to
●
the alarm unit.
LED con nuously on: Low-voltage indica on, please change the ba ery as
●
soon as possible.
Advanced features
The Tiiwee PIR sensor is equipped with some addi onal features to allow you
to adjust the device to your specific needs. To access these func ons, remove
the screw at the top of the sensor. Then separate the two parts (front and back
piece) by using an appropriate device (screwdriver, i.e.). Now you can see the
circuit board with the two switches.
1. The Indicator light can be switched off to save ba ery power ("Led off"
posi on). Off course, in this mode, an alarm signal will s ll be sent to the
Alarm Unit or the PIR Mo on Sensor Alarm.
low ba ery indica on is switched off in this se ng.
2. A wai ng me of 5 minutes between detec ons can be set saving ba ery
power ("5 Min" or "5s" switch). Use the 5-minute wai ng period when your
PIR sensor is meant to result in a loud siren alarm. We do not advise to use
this mode in combina on with the doorbell-sound se ng on your Alarm unit.
However, please note that the
17