Installing Your Tiiwee Home Alarm System In 4 Simple Steps - Tiiwee X4 Manual Del Usuario

Installing Your Tiiwee Home Alarm System in 4 simple steps

1. Unpack:
Unpack all kit components and lay them in front of you on the table.
2. Remove Ba ery Protec on:
X4 Siren: Remove the white ba ery protec on. You hear one beep, and the X4
Siren switches on automa cally.
Door sensors: Remove the white ba ery protec on at the back of the sensor
by pulling it.
4
3. Familiarize Yourself with Your System:
a. Arrange the X4 alarm unit such that the detec on window is facing away
from you.
b. Press the "S" bu on of the remote control un l you hear one of the
DingDong"-sounds.
c. Press the Ac va on bu on on the remote control to ac vate the X4 Siren.
You hear a short beep accompanied by one short red flash of the detec on
window.
d. Wave your hand approximately 50 cen meters in front of the detec on
window of the X4. You hear a "DingDong"-sound and the detec on window
of the X4 will light up.
e. Press the Deac va on bu on on the remote control to deac vate the X4
Siren. You hear 2 short beeps accompanied by 2 short red flashes of the
detec on window.
If you purchased a single X4 mo on sensor alarm your test stops here. You can
now install your system using the instruc ons in this manual.
Please con nue if you purchased a X4 mo on sensor alarm kit:
f. Arrange the window sensors such that the magnet is on the right-hand side
of each sensor. The li le triangles on the middle of the sides of the sensor
and the magnet cannot be more than 8 mm apart. Posi on them so that
they are facing each other.
f. Press the Ac va on bu on on the remote control to ac vate the X4 Siren.
You hear a short beep accompanied by one short red flash of the detec on
window.
h. Now move the magnet away from the first sensor. You hear the "DingDong"
-sound and the red light on the sensor will light up. Repeat this procedure
for all other window sensors.
5