Rese Ng The X4 Siren To Factory Se Ngs; Technical Specifica Ons Of The X4; Window & Door Sensors - Tiiwee X4 Manual Del Usuario

Door sensors:
Place a screwdriver or knife in the opening at
■
the bo om (Image) and use it as a lever to li
the case from the back plate.
Take out the old ba ery and replace it with a
■
fresh 12V/23A alkaline ba ery - please note the
correct polarity.
Put the ba ery cover back in place and push it
■
un l you hear a click.
PIR Mo on detectors: Slide off the back plate and replace the ba eries with
2 x AAA or 3x AAA ba eries depending on the model you use.

Rese ng the X4 siren to factory se ngs

This procedure will erase all informa on from the X4 siren which is related to
sensors and remote controls.
Take out one ba ery from the X4.
■
While keeping the Melody-bu on pressed, re-insert the ba ery. Con nue
■
to press the Melody-bu on.
A er a few seconds, you will hear 10 beeps with longer intervals followed
■
by another 5 beeps with shorter intervals.
Now, release the Melody-bu on.
■
The X4 restarts automa cally.
■
Your X4 Siren is now reset to factory se ngs. You can reconnect your
■
remote controls and sensors.
Technical specifica ons of the X4
Power supply : 4.5V - 3PCS * AA ba eries or external USB-5V power supply (not
included)Ba ery standby current: <300uA
Alarm Volume (siren): 120 dB
Working current: <100 mA
Shutdown current: <40 uA
Detec on range: <8 meter
Detec on angle: 110 degrees
Working humidity: <80%
Receiver frequency: 433 MHz
12
Window & door sensors
IMPORTANT: Please assure that the distance between magnet and sensor does
not exceed 8 mm.
Product Overview and Opera on
The door sensor consists of a magnet and a sensor which contains a detector
for changes in magne c fields ('flux'). When the magnet is moved away from
the sensor, the sensor will detect that mo on and will send a wireless signal to
the Tiiwee Alarm unit. The Tiiwee Alarm unit will now emit a powerful alarm
sound or a doorbell-sound depending on the se ngs of the Alarm unit.
Sensor
The instruc ons for pairing addi onal door sensor swith the Tiiwee alarm
system are included in this manual, or can be found on our website
www. iwee.com or one of our Youtube channels.
Installa on of Door sensors
GENERAL GUIDELINES:
Do not install the sensor near magne c parts - that might trigger the alarm
●
by accident.
Clean all surfaces before installa on.
●
It is essen al that the sensor and the magnet are placed on the door and
●
frame respec vely to allow an alarm to be triggered when the sensor and
magnet are separated.
Installa on examples
Various installa on examples are shown on the first page of this manual. Make
sure that both the installa on surfaces are clean and free from grease and dust.
Triangle marks
Magnet
13