Expanding Your System; Connec Ng Addi Onal Door Sensors; Connec Ng Pir Mo On Detectors - Tiiwee X4 Manual Del Usuario

Switching the red alarm light on or off
The X4 features a red alarm light. When the alarm is sounding or a mo on is
detected the red light will flash. However, in certain situa ons it might be
required to only have the siren sound and to have the red light switched off.
The red alarm light can be switched off, by simultanously pressing both the
Melody-bu on and the SET-bu on for 5 seconds. You will hear one beep as a
confirma on of the new se ng. The red alarm light can be switched on again
by repea ng the same procedure.

Expanding your system

Please note: You cannot add addi onal X4 sirens or other sirens to your system.
The X4 system can be expanded with more iwee door sensors and mo on
detectors from the Tiiwee Home Alarm System. Up to 20 sensors can be
connected to the each of the zones. Also, up to 20 remote controls can be
connected.
Warranty
Please only use accessories from the Tiiwee Home Alarm System to ensure a
proper func on of the system.
Connec ng addi onal sensors
Connec ng addi onal alarm sensors to a Normal zone
Deac vate the X4 siren by pressing the Deac va on bu on on the remote
■
control.
Press the Loudspeaker-bu on for 5 seconds. You will hear a beep and the
■
detec on window lights up.
Ac vate the door sensor by removing the magnet away from the sensor.
■
You will hear two beeps, and the detec on window will blink twice.
Save the se ng by pressing the SET-bu on briefly.
■
The door sensor has now been connected as an ordinary alarm sensor.
■
Connec ng sensors to an Emergency-zone
IMPORTANT: An emergency sensor will always trigger a loud siren alarm
regardless of if the X4 is ac vated or deac vated.
8
Deac vate the X4 siren by pressing the Deac va on bu on on the remote
■
control.
Press the Melody-bu on for 5 seconds. You will hear a beep and the
■
detec on window lights up.
Ac vate the door sensor by removing the magnet away from the sensor.
■
You will hear two beeps, and the detec on window will blink twice.
Save the se ng by pressing the SET-bu on briefly.
■
The door sensor has now been connected as an emergency sensor.
■
Connec ng sensors to a Doorbell zone
IMPORTANT: A doorbell sensor will never trigger a loud siren alarm. This
sensor will always trigger a "DingDong"-sound.
Deac vate the X4 siren by pressing the Deac va on bu on on the remote
■
control.
Press the Loudspeaker-bu on and Melody-bu on together for 5 seconds.
■
You will hear a beep and the detec on window lights up.
Ac vate the door sensor by removing the magnet away from the sensor.
■
You will hear two beeps, and the detec on window will blink twice.
Save the se ng by pressing the SET-bu on briefly.
■
The door sensor has now been connected as a doorbell sensor.
■

Connec ng PIR Mo on Detectors

Proceed as described with the door sensors in the previous chapter. However,
triggering the device is done by moving your hand in front of the mo on
detector. When performing the pairing procedure, make sure the mo on
detector is facing away from you to avoid unwanted signals from the device
while pairing it to the X4 Siren.
Connec ng remote controls
Up to 20 remote controls can be connected to the X4 siren.
Pairing remote controls
Deac vate the X4 siren by pressing the Deac va on bu on on the remote
■
control.
9