Dele Ng Accessories; Low Ba Ery Indica On; Replacing Ba Eries - Tiiwee X4 Manual Del Usuario

Press the Loudspeaker-bu on for 5 seconds. You will hear a beep and the
■
detec on window lights up.
Press one (any) bu on on the remote control(s) which you wish to
■
connect. You will hear two beeps for confirma on of correct pairing.
Press the SET-bu on shortly to store the se ngs
■
The remote control has now been connected to the X4 siren.
■

Dele ng accessories

Dele ng sensors from the Normal zone
IMPORTANT: With this procedure, all sensors are disconnected from the respec ve
zone. Reconnect any sensors you would like to keep in that zone. Please note that
also all remote controls are disconnected with this procedure.
Deac vate the X4 siren by pressing the Deac va on bu on on the remote
■
control.
Press the Loudspeaker-bu on for 5 seconds. You will hear a beep and the
■
detec on window lights up.
Press the Loudspeaker-bu on again for 5 seconds. You will hear 5 beeps
■
as a confirma on and the detec on window will flash 5 mes.
All sensor have been removed from the ordinary zone.
■
Dele ng sensors from an Emergency-zone
IMPORTANT: With this procedure, all sensors are disconnected from the
respec ve zone. Reconnect any sensors you would like to keep in that zone.
Disac vate the X4 siren by pressing the Deac va on bu on on the remote
■
control.
Press the Melody-bu on for 5 seconds. You will hear a beep and the
■
detec on window lights up.
Press the Melody-bu on again for 5 seconds. You will hear 5 beeps as a
■
confirma on and the detec on window will flash 5 mes.
All sensor have been removed from the emergency-zone.
■
Dele ng sensors from a Doorbell zone
IMPORTANT: With this procedure, all sensors are disconnected from the
respec ve zone. Reconnect any sensors you would like to keep in that zone.
Deac vate the X4 siren by pressing the Deac va on bu on on the remote
■
control.
10
Press the Loudspeaker-bu on and Melody-bu on simultanoulsy for 5
■
seconds. You will hear a beep and the detec on window lights up.
Press the Loudspeaker-bu on and Melody-bu on simultanously again for
■
5 seconds. You will hear 5 beeps as a confirma on and the detec on
window will flash 5 mes.
All sensor have been removed from the doorbell zone.
■
Disconnec ng remote controls
IMPORTANT: With this procedure, all remote controls are disconnected as well
as all the sensors in a Normal zone. Please make sure to reconnect the remote
controls and sensors you wish to con nue to use with the X4 siren.
Deac vate the X4 siren by pressing the SET-bu on on the X4 or the
■
Deac va on bu on on the remote control.
Press the Loudspeaker-bu on for 5 seconds. You will hear a beep and the
■
detec on window lights up.
Press the Loudspeaker-bu on again for 5 seconds. You will hear 5 beeps
■
as a confirma on and the detec on window will flash 5 mes.
All remote controls habe been removed from the X4.
■

Low ba ery indica on

Replace all ba eries immediately when this happens.
X4 Siren: You will hear 3 beeps every 20 seconds.
Door sensors: The red LED of the sensor will show a con nuous light.
PIR mo on sensors: The indicator light in the front is lit con nuously. When the
indicator light has been switched off manually, the low ba ery indica on will
not be shown.

Replacing ba eries

Remote control: The ba ery can be changed by removing the screw on the back
of the remote control. Open the remote control and remove the second screw
on the electronic board. This will give you access to the other side of the
electronic board, where the ba ery is located. The ba ery type is CR2032 (3V,
Lithium ba ery).
X4 Alarm unit: Remove the back panel and replace the ba eries with 3x AA size
1.5V alkaline ba eries. Do not use rechargeable ba eries.
11