GYS CARMIG Manual De Instrucciones página 17

MADE IN FRANCE
CHOICE OF REELS
The CARMIG machines can accommodate reels of 200 or 300 mm diameter.
Below are the different combinations possible:
Reel type
Steel
INOX
CuSi3
CuAl8
Alu AlMg5*
* We recommend a Teflon sheath (ref. 041578) and special Aluminium contact tip (Ø 0.8 ref. 041059 – Ø 1.0 ref. 041066)
CONTROL PANEL (FIG IV)
1- Voltage selection button min/max.
2- Wire speed regulator.
DIRECTIONS OF USE
CARMIG feature allows you to adjust the voltage and the wire speed.
Use the SMART table to find the correct settings based on the type of wire, and the thickness of the metal work piece.
Then based on the recommendation indicated, simply select:
• The voltage (rotating witch with 7 positions)
• Wire speed - adjust the regulator (2) to the colour zone indicated.
Examples:
To weld 0.8 mm thick steel, using 0.8 mm diameter steel wire:
• Move the rotating switch (1) to the position 1.
• Move the regulator (2) to the zone of lightest blue colour and adjust "by sound" if required.
ADVICE AND THERMAL PROTECTION
• Respect the normal rules of welding
• Leave the machine plugged in after welding to allow it to cool
• Thermal Protection : The LED will illuminate. Cooling will take between 10 and 15 minutes depending on the ambient
temperature.
MAINTENANCE
• Maintenance should only be carried out by a qualified person.
• Switch the machine off, ensure it is unplugged, and that the ventilator inside has stopped before carrying out mainte-
nance work. (DANGER High Voltage and Currents).
• GYS France recommends removing the steel cover 2 or 3 times a year to remove any excess dust. Take this opportunity
to have the electrical connections checked by a qualified person with an insulated tool.
• Regularly check the condition of the power supply cord. If damaged, it will need to be replaced by the manufacturer,
its' after sales service or a qualified person.
• Ensure the ventilation holes of the device are not blocked to allow adequate air circulation.
OUR ADVICE
• Ensure the ventilation holes of the device are not blocked to allow adequate air circulation.
• Change the contact tip and the nozzle of the torch on a regular basis.
• Ensure the torch and sheath are free from aluminium and steel dust.
• Avoid MIG/MAG welding in draftee areas.
CARMIG
Torch
Ø 300
Ø 200
Steel torch included
Ø 200
Ø 200
Ø 200
Ø 300
Alu torch not included
Ø 200
Gaz
Argon
+ CO2 or Pure CO2
Pure argon
3- « SMART » settings table MIG/MAG.
4- Thermal Protection light.
EN
17