Heath Zenith 6117 Manual De Instrucciones página 9

WARNING: Turn power off at the fuse
or circuit breaker before wiring.
SINGLE MOTION SWITCh
INSTALLATION
Connect the wall switch as shown here.
DUAL MOTION SWITCh INSTALLATION
If you want to have motion sensors at both 3-way
switches, connect them as shown below.
FROM
POWER
SOURCE
FROM
WHITE
POWER
SOURCE
BROWN
RED
OFF
( 3-WAY
MOTION
SWITCH )
*COMMON-Used for illustrative Purposes Only. Check Your Switch. The common may be in a different location, depending
on the brand of your switch.
RED is used to represent the travel wire between two standard three-way switches. This may not be the color used in all
installation. If you are not sure about your wiring, call an electrician for installation help. There is also a RED wire on the 3-way
motion switch. Check the instructions above closely and do not confuse the two.
598-1373-01
SPECIAL INSTALLATIONS
TYPICAL 3-WAY INSTALLATION
WHITE
*COMMON
BLACK
DUAL SWITCH INSTALLATION
WHITE
3-WAY
MOTION
SWITCH
BLACK
BLACK
AUTO ON
To EARTH
GROUND
SINGLE SWITCH INSTALLATION
MOTION SWITCH
BLACK
BLACK
FROM
POWER
SOURCE
To EARTH
GROUND
WHITE WHITE
*COMMON
RED
(In Wall)
BLACK
BLACK
RED
OFF AUTO ON
(3-WAY
MOTION
SWITCH)
9
3-WAY
BROWN
BLACK
RED
OFF AUTO ON
WHITE
BLACK
WHITE
3-WAY
MOTION
SWITCH
BROWN
BLACK
To EARTH
GROUND
RED (In Wall)
WHITE