Placing Tool In Service - Ingersoll Rand 302 Manual De Instrucciones

LUBRICATION
Ingersoll–Rand No. 10
Always use an air line lubricator with this tool.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International – No. C08–C2–FKG0
For USA – No. C08–02–FKG0–28
After each two hours of operation, if an air line
lubricator is not used, inject 1/2 to 1 cc of Ingersoll–Rand
No. 10 Oil into the Air Inlet.
Periodically as experience indicates, remove the Spindle
Bearing Cap and lubricate the Pinion and Pinion Gear
with 2 cc of Ingersoll–Rand No. 67 Grease. Excessive
lubrication will cause grease to work out around the
Spindle Collet Body.
Model Type of
Handle
302, 302–EU Inline
H Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance with ISO8662–1 with artificial unbalanced load at 50% of rated speed for ungoverned tools and at
80% rated free speed for governed tools.
•
ISO3744

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 67
SPECIFICATIONS
Collet size
Speed
1/4" 18,000
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
H Sound Level
Free
dB (A)
Pressure
97.9
3
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
Level
•Power
2
m/s
110.9 1.1