Placing Tool In Service - Ingersoll Rand 99H–EU Serie Manual De Instrucciones

WARNING: Incorrect combinations of grinding wheel, wheel guard and tool speed could result in injury.
Correct combinations are specified below:
Guard Part Number
88H60–961A
99H45–981
LUBRICATION
Ingersoll–Rand No. 50
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
International – No. FRL30–C6–A29
Where lubricators cannot be permanently mounted, we
recommend using an Ingersoll–Rand No. 8LUB12
Lubricator.
Before starting the tool, unless an air line lubricator is
used, detach the air hose and inject about 1.5 cc of
Ingersoll–Rand No. 50 Oil into the air inlet. Remove the
Oil Chamber Plug and fill the chamber.
After each 8 hours of operation, or as experience
indicates, remove the Oil Chamber Plug and fill the
chamber.
Model Free
Speed
rpm
99HL45H108–EU 4 500
99HL60H106–EU 6 000
99HL60H108–EU 6 000
99HG45H108–EU 4 500
99HG60H106–EU+ 6 000
G Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance with ISO8662–1 with artificial unbalanced load at 50% of rated speed for ungoverned tools and at
80% rated free speed for governed tools
• ISO3744
+ Tested in accordance with PNEUROP PN8NTC1
GRINDER SPECIFIC WARNINGS
Wheel Type Wheel Diameter
in. (mm)
1 6 (152)
1 8 (203)

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 28
SPECIFICATIONS
Type of Type 1 Wheel
Handle
inches mm
lever 8 203
lever 6 152
lever 8 203
grip 8 203
grip 6 152
Maximum Wheel
Thickness
in. (mm)
1 (25.4)
1 (25.4)
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
FILTER
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
GSound Level
Spindle
and Guard
Pressure
5/8"–11 8" 82
5/8"–11 6" 85.8
5/8"–11 8" – – –
5/8"–11 8" – – –
5/8"–11 6" 85.8
3
Maximum Speed
rpm
6 000
4 500
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
dB (A) Level
•Power
2
m/s
– – – 2.4
98.8 3.7
– – – – – –
– – – – – –
98.8 2.4