Placing Tool In Service - Ingersoll Rand 61H–EU Serie Manual De Instrucciones

WARNING: Incorrect combinations of grinding wheel, wheel guard and tool speed could result in injury.
Correct combinations are specified below:
Guard Part Number
61H–931A
LUBRICATION
Ingersoll–Rand No. 50
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
International – No. C28–C4–FKG0
Before starting the tool, unless the air line lubricator is
used, detach the air hose and inject about 2.5 cc of
Ingersoll–Rand No. 50 Oil into the air inlet. Remove the
Oil Chamber Plug from the Throttle Handle and fill the
chamber.
After each eight hours of operation, or as experience
indicates, replenish the oil supply in the Handle.
Model
61H120G4–EU
61H150G4–EU
61H120L6–EU
61H150L6–EU
61H120H63–EU
61H120H64
61H150H63–EU
G Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance with ISO8662–1 with artificial unbalanced load at 50% of rated speed for ungoverned tools and at
80% rated free speed for governed tools.
• ISO3744
GRINDER SPECIFIC WARNINGS
Wheel Diameter
Wheel Type
1

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 68
SPECIFICATIONS
Free Speed
rpm
12,000 1/4" Erickson Collet
15,000 1/4" Erickson Collet
12,000 3/8"–24 Spindle
15,000 3/8"–24 Spindle
12,000 3/8"–24 Spindle, 3" Guard
12,000 3/8"–24 Spindle, 4" Guard
15,000 3/8"–24 Spindle, 3" Guard
Maximum Wheel
in. (mm)
3 (76)
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Spindle
Pressure
– – –
– – –
3
Maximum Speed
Thickness
in. (mm)
1/2 (12.7)
FILTER
COMPRESSOR
(Dwg. TPD905–1)
GSound Level
dB (A)
•Power
86.6 99.6
89.8 102.8
86.6 99.6
89.8 102.8
86.6 99.6
– – –
– – –
(rpm)
15,000
♦Vibrations
Level
2
m/s
1.6
1.5
8.2
7.5
8.2
– – –
– – –