Thermal Overload Protector; Extension Cord Use - Campbell Hausfeld CT1001 Manual De Instrucciones

Operating Instructions
Maintenance (Continued)

THERMAL OVERLOAD PROTECTOR

This compressor is equipped with a
manual reset thermal overload protector
which will shut off motor if it becomes overheated.
If thermal overload protector shuts motor OFF frequently look
for the following causes:
1� Low voltage
2� Clogged intake port (located on pump crankcase)
3� Lack of proper ventilation
If the thermal overload protector is
actuated, the motor must be allowed to cool
down for 30 minutes before manually resetting.
After the unit has cooled down for 30 minutes, manually reset
the thermal overload protector by pushing the button shown in
Figure 5�
STORAGE
1� When not in use, store hose and compressor in a cool, dry
place�
2� Drain tank of moisture
3� Disconnect hose and hang open ends down to allow any
moisture to drain�

EXTENSION CORD USE

If an extension cord has to be used, use the appropriate cord based on the charts below� See Amp Rating decal on unit�
Length of Cord in Feet
AWG Size of Cord
Length of Cord in Feet
AWG Size of Cord
6 www.chpower.com
Figure 5
Extension cords for 120V / 3 to 4 Amp Units
25 50
18 18
Extension cords for 120V / 6 to 8 Amp Units
25 50
18 16
100 150 200
16 141 12
100 150 200
12 10 10
Thermal
overload
protector
250 300 400
12 10 10
250 300 400
8 6 6
500
8
500
6