Administration > Log; Administration > Diagnostics; Administration > Factory Defaults - Cisco Linksys WRT54G2 Guia Del Usuario

Chapter3
Administration > Log
The Router can keep logs of all traffic for your Internet
connection.
Administration > Log
Log
Log To disable the Log function, keep the default setting,
Dsable. To monitor traffic between the network and the
Internet, select Enable.
When you wish to view the logs, click Incomng Log or
Outgong Log, depending on which you wish to view.
Click Save Settngs to apply your changes, or click Cancel
Changes to cancel your changes.
Administration > Diagnostics
The diagnostic tests (Ping and Traceroute) allow you to
check the connections of your network components.
Administration > Diagnostics
Ping Test
Png
The Ping test checks the status of a connection.
Click Png to open the Ping Test screen. Enter the address
of the PC whose connection you wish to test and how
many times you wish to test it. Then, click Png. The Ping
Test screen will show if the test was successful. To stop the
test, click Stop. Click Clear Log to clear the screen. Click
Close to return to the Diagnostics screen.
Wreless-G Broadband Router
Advanced Configuration
The Ping Test
Traceroute Test
Traceroute
To test the performance of a connection,
click Traceroute to open the Traceroute Test screen. Enter
the address of the PC whose connection you wish to test
and click Traceroute. The Traceroute Test screen will show
if the test was successful. To stop the test, click Stop. Click
Clear Log to clear the screen. Click Close to return to the
Diagnostics screen.
The Traceroute Test
Administration > Factory Defaults
The Administration > Factory Defaults screen allows you
to restore the Router's configuration to its factory default
settings.
Factory Defaults
Restore Factory Defaults
to the default values, select Yes, and then click Save
Settngs. Any settings you have saved will be lost when
the default settings are restored.
Administration > Factory Defaults
To reset the Router's settings
20