How To Set Alarm - Tivoli Audio Albergo Manual Del Usuario

H. Clock Set: Press the Select button and use the pq arrow and Select buttons
to set/change the hour, then press Select. Repeat this process to set/change the
minutes, then press Select.
Volume Limit (NOT IN AM OR FM MENUS): If you wish to reduce the maximum
I.
volume level so as not to disturb others, press the Select button and use the
pq arrow and Select buttons to choose between Volume limit 26 or 22.
Selecting "Off" keeps the maximum volume at the factory default setting of 30.
Note: Reducing the overall volume level will also reduce the level of the alarm's
volume when the alarm sounds.
J. Alarm 2 (NOT IN AM OR FM MENUS): If you do not expect to use Alarm 2 or
are afraid Alarm 2 may be set in error, press the Select button and use the pq
arrow and Select buttons to Disable Alarm 2.
K. Bluetooth Level: Use the pq and Select buttons to select "Low" should you
wish to reduce the range of the Bluetooth signal. This may be desirable if the
Bluetooth feature will only be used when you are in very close proximity to the
radio. We recommend this setting remain in the "Normal" position.
3. TIVOLI EQ
A. Bass: Press Select and use the pq arrow and Select buttons to adjust the bass.
B. EQ: The equalizer acts as a Loudness control at low volume levels. Use the pq
buttons to select between having the EQ on, having the EQ always off, or the
EQ off until the Albergo is turned off (when it is turned on again the EQ will be on
again).
C. Balance: As the balance control has no effect when the Albergo is set to Mono,
this setting should remain in the center position, except when the optional
Albergo Speaker is connected and Stereo mode is selected via the remote con-
trol's "Mono" button. Though we still recommend the center balance setting in
Stereo mode, you may use the pq buttons to adjust the balance to your liking,
and press the Select button.
D. Treble: Press Select and use the up/down arrow and Select buttons to adjust
the treble and press the Select button.
How to Change Alarm Settings and Set the Alarm Via
the Main Menu
1. With the Albergo powered on, access the alarm settings by pressing the Alarm button
on the remote.
2. Alarm 1 is shown first. Use the pq and Select buttons to choose between Alarm 1
and Alarm 2.
3. Use the pq and Select buttons to set the alarm on or off.
4. Use the pq buttons to set/change the hour, then press Select. Repeat this process to
set/change the minutes, followed by AM/PM (if time is set to 12 hour format), then press
Select. Note: At any point you can navigate through the alarm menu by using the back
or left arrow buttons, and the Select or right arrow buttons.
5. Use the pq buttons to set how often the alarm should be set to wake, then press Select.
12 – ENGLISH