Alarm Options; Bluetooth Operation - Tivoli Audio Albergo Manual Del Usuario

6. Use the pq buttons to select the source you wish to wake to, then press Select. If
you set the source to AM or FM, use the pq buttons to select the station preset (if
presets have been stored) or last listened, then press Select.
7. Lastly, use the pq buttons to set the volume level of the alarm, then press Select.
8. Repeat this process for Alarm 2 if desired.
If you make a mistake at any point in the process, press the Back button on the remote and
begin again.
Power Loss: Should power be lost, or the Albergo becomes disconnected, the alarm
time will be saved but the Albergo alarm cannot sound if there is no power.

Alarm Options

When the alarm sounds you can activate the Snooze feature or shut the alarm off.
Snooze: To activate Snooze while the alarm is sounding, press the Snooze button on the
remote, or briefly press the Multi-Function Control Wheel on top of the unit. The Snooze
time is not adjustable. Pressing the Snooze button again while still in Snooze mode will
re-set the Snooze timer back to 10 minutes.
Alarm off: To stop the alarm while it is sounding, press the Alarm button on the unit or
remote. You can also press the Power button on the remote.
Alarm Quick Set: With the Albergo in Standby, repeatedly press the alarm button on the
remote briefly to toggle each alarm on or off.

Bluetooth Operation

Prior to pairing, verify your device supports Bluetooth 2.1+EDR A2DP and your device is
not connected to any other Bluetooth product. Devices may pair differently. Below is a
general guide.
1. Press the Albergo's front panel Bluetooth button or change the source to Bluetooth.
This will power on the Bluetooth. Turn the volume up about ¼ to start. Also turn up the
volume on the source device (the device you are streaming from).
2. Turn on the Bluetooth wireless technology on your enabled device.
3. Select "Tivoli Bluetooth (Not Paired)" when it appears on your device's screen to
initiate searching. Some devices may prompt you for a PIN. If so, enter "0000". "Tivoli
Bluetooth" will change from "Not Paired" to "Connected".
4. You will hear a ring tone from the Albergo confirming connection and you can begin
playing your music files wirelessly. Adjust the volume level on your device. You should
not have to pair your device again. Depending on your device, you may need to
make multiple attempts at Pairing and/or Connecting to the Albergo, but please
give your device adequate time to Pair or Connect before repeating the process.
Pairing A Bluetooth Wireless Technology Enabled
iPhone/iPod Touch/iPad
1. Press the Albergo's front panel Bluetooth button or change the source to Bluetooth.
This will power on the Bluetooth. Turn the volume up about ¼ to start. Also turn up the
volume on the source device (the device you are streaming from).
13 – ENGLISH