In Case Of Difficulty - Texas Instruments TI.5032SV Manual Del Usario

ENG (English)
Symbols
+ Addition to the add register.
– Subtraction from the add register.
◊ Add register subtotal; tax in a tax calculation; profit or
loss in a # calculation.
... Result after 3, >, E, P or Q; selling price
in a # calculation.
× Multiplication.
÷ Division.
= Completion of a multiplication or division.
Item cost in a # calculation.
M
M
+ Addition to memory.
M
– Subtraction from memory.
M
◊ Memory subtotal.
M
∗ Memory total.
% Percentage in a > calculation; percentage of profit or
loss in a # calculation; tax for
+
% Result of a percent add-on calculation.
–
% Result of a percent discount calculation.
C 2 was pressed.
# Precedes a / entry.
– (minus sign) Value is negative.
M A nonzero value is in memory.
E An error or overflow condition has occurred.
Errors and Overflows
Correcting Entry Errors
2 clears an entry if no operation key was pressed.
Pressing the opposite operation key cancels an entry if an
operation key was pressed. (9, ., N, and F only.)
% deletes the rightmost digit if no operation key was
pressed.
9 restores the value to the add register after E.
N restores the value to the memory after 0.
Error and Overflow Conditions and Indicators
An error condition occurs if you divide by zero or calculate
a selling price with a margin of 100%. The calculator:
0 Prints 0 .... and a row of dashes.
0 Displays E and 0.
An overflow condition occurs if a result has too many
digits for the calculator to display or print. The calculator:
0 Displays
decimal point 10 places to the left of its correct
position.
0 Prints a row of dashes and then prints the first ten
.
TAX=SET
digits of the result with the decimal shifted 10 places
to the left of its correct position.
Clearing an Error or Overflow Condition
2 clears any error or overflow condition. The memory
is not cleared unless the error or overflow occurred in a
memory calculation.
and the first 10 digits of the result with a
E

In Case of Difficulty

1. If the display becomes dim or the printer slows or
stops, check that:
0 The batteries are fresh and properly installed.
0 The adapter is properly connected at both ends
and POWER=ON , PRT , or IC .
2. If there is an error or the calculator does not respond:
0 Press 2. Repeat the calculation.
0 Turn the power off for ten seconds and then back
on again. Repeat the calculation.
0 Review the instructions to be sure you entered the
calculations correctly.
3. If no printing appears on the tape, check that:
0
POWER=PRT or IC .
0 .
TAX=CALC
0 The ink roller is snapped firmly in place and has
not run out of ink.
4. If the paper jams:
0 If near the end, install a new roll of paper.
0 Make sure you are using quality bond paper.
ENG (English) 6