Installing Car Seat In Vehicle; Important - Graco EZ Latch Manual De Instrucciones

❃

Installing Car Seat In Vehicle

Follow instruction manual provided with
car seat for installation in vehicle; use the
™
EZ LATCH in place of the vehicle seat belt.
For ease of installation, extend EZ LATCH
1
to its maximum length.
Position car seat, rear-facing or
2
forward-facing, correctly for your child
(Fig. a or Fig. b).
IMPORTANT: Release Buttons must face up
and Adjuster must face outward so belt can
be adjusted without interference (Fig. a).
Thread EZ LATCH
3
path normally used for vehicle seat belt, as
shown in car seat manual.
Belt must lay flat and not be twisted.
4
Hook Connectors to vehicle lower anchors.
Pull firmly on Connectors to be sure they are
attached (Fig. c).
5
™
through car seat belt
5
Tighten EZ LATCH
on car seat and pulling the adjustment belt
(Fig. d).
™ 6
Test car seat for secure installation as
described in car seat instruction manual by
pulling front-to-back and left-to-right.
Check that the EZ LATCH
7
does not slip from the tightened position.
If it does not stay tight, try another seating
position or contact Customer Service.
For forward-facing car seats only, attach the
8
top tether strap and tighten top tether strap.
Forward-facing car seats SHOULD use a top
tether strap in addition to EZ LATCH
If you do not have a top tether strap, call
1-888-224-6549 with your model number
and date of manufacture to see if a top tether
strap is available for your model.
Each trip check that car seat is securely
installed; tighten if necessary.
™
by pushing down hard
™
stays tight and
™
.