External Aerial; Adi Interface; Electric Connections Table - V2 FORTECO Manual De Instrucciones

EXTERNAL AERIAL

We suggest to use the external aerial (model: ANSGP433) in
order to guarantee the maximal range.
Connect the antenna hot pole to terminal P1 of the control unit
and the braiding to terminal P2.
INTERFACE
The ADI (Additional Devices Interface) interface of the control
unit PD18 allows the connection to V2 optional modules.
Refer to V2 catalogue or to the technical sheets to see which
optional modules with ADI interface are available for this control
unit.
WARNING: Please read the instructions of each single
module to install the optional modules.

ELECTRIC CONNECTIONS TABLE

P1 Antenna
P2 Antenna shield
Opening control for the connection of control
P3
devices with N.O. contact
Opening controls for pedestrian access for the
P4
connection of control devices with N.O. contact
P5 Stop command. N.C. contact
P6 Common (-)
P7 Photocells type 1. N.C. contact
P8 Photocells type 2. N.C. contact
P9 Safety ribbons type 1 (fixed). N.C. contact
P10 Safety ribbons type 2 (mobile). N.C. contact
P11 Common (-)
Power output 24 VAC for photocells and other
P12 - P13
accessories
P13 - P14 Photocell TX power supply for functional test
B1 - B2 Courtesy light
Flashing light
B3 - B4
L Power phase 230 VAC / 120VAC
N Neutral 230 VAC / 120VAC
Interface
MAINS It shows that the control unit is power supplied
It shows that there is an overload on accessories
OVERLOAD
power supply
Here the description of the connectors already connected on
the left side of the control unit
WARNING: Do not remove or invert the connectors
FC Limit switch
SW Release switch
ENCODER Encoder (accessory code 162328)
M Motor
C1 Running capacitor (BLACK SHEATH)
C2 Start off capacitor (RED SHEATH)
PLEASE NOTE: to install the encoder, please follow the
instructions reported in the manual provided with the
encoder carefully.
36
230VAC 40W (PD18)
120VAC 40W (PD18-120V)