Product Set-Up - D-Link GO-RTW-N300 Guia De Instalacion

PRODUCT SET-UP

EASY SETUP WIZARD
RT
Outlet
Internet
Internet
Router
Internet
Save
ADVANCED SET-UP (ACCESS VIA IP ADDRESS)
To configure GO-RTW-N300 manually connect your computer to the GO-RTW-N300 using the
ethernet cable. Then plug the GO-RTW-N300 into a wall. The power light will display as solid Blue.
Then simply open a browser window and enter the IP address in the browser address field:
GO-RTW-N300
Step 1
Find an outlet close to an Internet- enabled device.
Then, move the switch to "RT Mode" and plug
the GO-RTW-N300 into a wall outlet. Verify that the power
LED has turned Blue.
Step 2
Connect one end of the Ethernet cable into the Ethernet port of
the Internet-enabled device (e.g. modem, router) and then plug the
other end of this cable into the GO-RTW-N300 INTERNET port.
Step 3
Plug one end of the Ethernet cable into the GO-RTW-N300 LAN
port. Plug the other end of the cable into your PC 's Internet port.
You may also connect to the router wirelessly.
Step 4
From the computer you connected to the router, open a web browser
and go to http://192.168.0.1. Enter admin as the User Name, and
leave the Password field blank. You may use the Setup Wizard to
configure your GO-RTW-N300.
IP ADDRESS: http://192.168.0.1
USERNAME: admin
PASSWORD: [blank]
5