Publicidad
Idiomas disponibles
Idiomas disponibles
Remote mount installation
Attach remote hose by sliding over the nozzle
9
and adapter. Secure both hose ends with
clamps (provided).
M24771
To install clamps onto the insulated steam hose:
A
Cut a slit in the insulation half way around the house. Do not cut into the steam hose.
Insert the hose clamp into the slit and hook it onto the hose.
B
A
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
http://yourhome.honeywell.com
® U.S. Registered Trademark.
© 2008 Honeywell International Inc.
69-2276EFS—01 M.S. 09-08
69-2276EFS_A.indd 8
IMPORTANT:
Run hose continuously uphill. For horizontal runs, ensure a slope of 2 in.
uphill per foot. Secure hose every horizontal foot using clamps (provided).
For long horizontal runs, support the hose by first securing a length of 2 x
4 lumber, U-channel, or angle iron with the appropriate slope. Then attach
the hose to the top of this support. If remote hose requires downward pitch,
refer to page 4 for instruction.
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Toronto, Ontario M1V 4Z9
Printed in U.S.A. on recycled
paper containing at least 10%
post-consumer paper fibers.
B
9/25/2008 9:26:55 AM
Publicidad
