2.3.2
CALL BUTTON TO VIDEO DOOR PHONE ASSOCIATION
Video door phone associated with
the call button 1
2.3.3
LINE TERMINAL
The line termination must be activated on a video door phone connected at the end of a line without a new
section restarting from the LINE OUT terminals.
Terminal insert (default)
2.4
INSTALLATION COMPLETION
Connect.
Fix the video door phone to the bracket.
1
2
2.5
PROGRAMMING THE INTERCOM FUNCTION
The system offers the option of programming 2 buttons (1
With the kit Ref. 1722/83 you can call up to 2 video door phones in the same apartment.
With the kit Ref. 1722/84 you have two calling options:
•
up to 2 video door phones in the same apartment,
•
1 video door phone in the same apartment and all video door phones of the other apartment.
To programme the buttons:
•
Go to the indoor station to be programmed as caller (indoor station A).
•
Press and hold
confi rmation beeps to confi rm the new setting.
•
Press the button to be programmed as "caller" (
confi rmation tone.
•
Go to the indoor station to be called by that button (indoor station B) and press the door-key button. The
indoor stations A and B will emit a beep to confi rm the new setting.
•
To exit the programming mode, press and hold
In any case, after 10 minutes the device will automatically quit the programming mode, saving
the edited parameters.
With the kit Ref. 1722/84, the call to a video door phone in the second apartment will
necessarily sound all video door phones in the apartment.
14
Dip switch
position
ON
1
Call button 1
→
Dip switch
position
ON
1
To remove the video door phone from
the
bracket,
screwdriver into the seating as indicated
in the figure and push the video door
phone upwards.
for more than 5 seconds; the red LED will fl ash slowly and the system will emit 3
Video door phone associated with
the call button 2
2
3
4
Call button 2
←
Terminal not inserted
2
3
4
insert
the
and
or
) for at least 3 seconds until you hear the
for more than 5 seconds on the indoor station A.
tip
of
a
2
) to make intercom calls.
Dip switch
position
ON
1
2
3
4
Dip switch
position
ON
1
2
3
4
1
DS1722-099