GE VAT300 Guía Rápida página 18

Chapter 3 Outline of operation panel types and functions
LCD operation panel (U30 V24OP1)
Data display section (LCD)
LED operation panel (U30 V24OP2)
Data display section (LED)
• A protective sheet is attached to the surface of the panel when shipped. Peel of this sheet before
starting use.
• Do not drop the panel. The panel could break if strong impact is applied.
• If the display does not appear even when the inverter power is turned ON, the cable between the
panel and inverter might not be connected properly. Check the connection.
Status indications LEDs
The drive is running in
FWD (Forward)
the forward direction.
The drive is running in
REV (Reverse)
the reverse direction.
The drive has detected a fault and has stopped.
Turns OFF when the
FLT (Fault)
signal is input.
The drive is in the Local Mode and can be operated from the Operation Panel (FWD,
REV and STOP only). When LED is off, the drive is in the Remote Mode and can be
controlled from the terminal block (sequence input signals). To change Modes
LCL (Local)
between Local and Remote, press
Change this setting while operation is stopped.
Unit indications LED
CAUTION
When both LEDs flicker simultaneously, it indicates that DC
Brake or pre-excitation is in action.
If only the "FWD" or "REV" LED is flickering, this indicates
that a command in the reverse direction has been received,
and the drive is decelerating.
keys are pressed or the sequence input RESET
STOP RST
＋
MOD
.
STOP LCL
＋
SET
EN-16
Parameter increase/decrease knob
Unit indications LED
Parameter operation keys
Operation keys
Parameter operation keys
Sign display LED
Parameter increase/decrease keys
Unit indications LED
Parameter operation keys
Operation keys
Parameter operation keys