Sangean TunPad DPR-202BT Instrucciones De Manejo página 9

Prune stations-DAB
Over time, some DAB services may stop broadcasting, or may change location and then
not be able to receive a station. In order to remove such stations from the DAB station
list, the Prune stations function will delete the DAB stations from your station list that
can no longer be received.
Stations which cannot be found or which have not been received for a very long time
are shown in the station list with a question mark.
1. Press the Power button to switch on your radio.
2. Press the Source button until the DAB mode is selected.
3. Press and hold the Menu button until the Advanced DAB menu shows on the display.
4. Press the Tuning up/down button until 'Prune' appears on the display. Press the
Select button to enter the setting.
5. Press the Tuning up/down button to highlight 'Yes'. Press the Select button to cause
the stations list to be pruned, eliminating unavailable stations.
6. f you do not wish to prune stations highlight 'No' in step 5 and then press the Select
button. The display will revert back to the previous display.
Note:
If you have moved to a different part of the country you should also carry out a search
for new stations (please see the section 'Finding new stations' in the previous section).
Operating your radio-FM auto-tune
1. Straighten up the antenna.
2. Press the Power button to switch on your radio.
3. Press the Source button until the FM band is selected.
4. Press and hold the Tuning up/down button to carry out an auto-tune. Your radio will
scan up the FM band from the currently displayed frequency and will stop scanning
automatically for a few seconds when it finds a station of sufficient strength. Then it
will continue the next station search.
5. After a few seconds the display will update. The display will show the frequency of the
signal found. If the signal is strong enough and there is RDS data present then the
radio may display the station name.
6. To find other stations press the Tuning up/down button as before. When the end of
the waveband is reached, your radio will recommence tuning from the opposite end of
the waveband.
7. Adjust the Volume to the required setting.
8. To switch off your radio, press the Power button.
Note:
If you find that FM reception is poor, try repositioning the antenna.
8