Silverline 793750 Traducción Del Manual Original página 7

793750
Maintenance
WARNING: Always disconnect from the air supply and depressurise before cleaning or carrying out
any maintenance.
Replacing blades
Blade Assembly
Bushings
Note: Periodically inspect and replace blades as necessary. All three blades are available to purchase
separately (see 'Accessories'), however, it is recommended to always replace them as a set.
1. Remove the Blade Retaining Bolts (4) using a 4mm hex key (not included)
2. Remove the centre blade first, then the left and right blades and bushing
3. Replace with new blades. Place the bushing between the new left and right blades (see Fig. II),
and insert into the Blade Assembly (1)
4. Insert the three previously removed blade retaining bolts into the body of the blade assembly,
and tighten all three bolts with the hex key
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth
IMPORTANT: There is very little that can go wrong with your air tool and it should be noted that
when an air tool fails to work it is generally because the internal workings have corroded due to
dirty, wet air and failure to follow the instructions given below.
Daily maintenance procedure: Disconnect from the air supply, pour the equivalent of a
tablespoon of oil into the air intake. Operate the machine at low speed to thoroughly lubricate all
internal workings.
• If the machine is in constant use or used for long periods at a time, a combined filter/lubricator
must be fitted. There must be an air filter fitted at all times
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL
• Failure to comply with the operating and maintenance instructions may invalidate the guarantee
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
• As with other power tools, air tools should not be disposed of with household waste
• Air tools may contain traces of tool oil and other lubricants and so must be recycled accordingly
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
4
FIG. II
Air Sheet Metal Shear
silverlinetools.com
7