Installing The Refrigerator; Electrical Connection - Furrion Arctic FCR10DCDTA Serie Manual De Instrucciones

wire may need to be re-routed into the cabinet if the
entryway point is not within the 1/4" spacing.
● If no sidewall access panel/vent is available to reach
the rear wire connection of the appliance, plan for the
appropriate wire length to reach outside of the cabinet so
the wire connection can be made before installing.
NOTE: Furrion recommends dropping the 12V feed wire
from the upper rear of the cabinet down to the terminal
block. Temporarily affix the wires to the upper half of the
appliance with tape so that excess wire will droop without
risk of rubbing with the appliance chassis and floor during
installation.
Drainage Preparation
The cavity condensate drainage is captured in a drain pan
integrated with the unit. No external drainage needs to be
prepared at this point.

Installing the Refrigerator

Electrical Connection

1. Remove the strain relief and connector cover using a
Phillips screwdriver. (Fig. 1)
Fig. 1
2. Connect the cables to the correct terminals as shown in
Fig. 2. Connect the terminal "+" to the 12V DC positive pole
connect the terminal "-" to the 12V DC negative pole.
3. Connect additional chassis grounding to the Terminal
block labeled "GND" if desired.
Fig. 2
4. Fix the cable with the strain relief and replace the
connector cover. (Fig. 3)
Fig. 3
Installation without Sidewall Access
1. Slide the unit into the enclosure. Care should be taken
to avoid rubbing the chassis and wire together during
installation. (Fig. 4)
NOTE: Elevating the wire and use of wire sheathing/wire
loom will help protect the wire.
Fig. 4
+ -
GND
1 2 3
7