Installing The Air Extraction System; Requirements For The Suction Unit; Installing The Suction Unit - Ivoclar digital PrograMill Dry Instrucciones De Uso

EN 18

Installing the air extraction system

Ivoclar Vivadent recommends the use of the PrograMill
Suction Unit.

Requirements for the suction unit

You can find specific values and additional require-
ments in the chapter on technical data.
data – on page 11
Use a suction device with the following properties
only:
Designed for the commercial use in the dental
n
sector, such as PrograMill Suction Unit
Equipped with a filter of the filter class M
n
Equipped with safety devices which protect you
n
from static discharges (e. g. through an anti-static
suction hose)
Minimum extraction capacity: 2,500 l/min
n
(88.3 cfm)

Installing the suction unit

You can install the suction unit as follows:
1. Read the documentation for the suction unit. Fol-
low the operating and safety instructions at any
time.
2. Check if the connection of the suction hose has
an outer diameter of 45 mm. If the diameter is dif-
ferent, either adjust the hose or use the adapter
delivered with the machine.
3. Insert the suction hose of the suction unit into the
opening for the air extraction of the machine.
Ensure that the suction hose is properly seated.
F . 15 – I
IG NSERTING THE SUCTION HOSE INTO THE
MACHINE
4. If you want the machine to automatically switch
the suction unit on and off:
Connect the data cable provided by the manu-
facturer of the suction to the suction control
connection of the machine. The operating

Technical
Operating Instructions: PrograMill Dry
Version: 2/19/2021
PrograMill Dry – Installing the machine
instructions of the suction unit contains further
details.
5. Continue with the installation of the suction unit as
described in the documentation of the unit.