Festo DNCKE Serie Instrucciones De Utilizacion página 24

DNCKE-.../KEC-...
Select the fitting variant to suit your application.
S
Further fitting possibilities for Fig. 9 and the necessary accessories are de-
scribed in the Festo catalogue.
Variants (examples)
With foot fastening type HNC-...
Fig. 9
Place the clamping unit in the intended position.
S
Tighten the fastening screws to an equal extent.
S
The tightening torques are shown in the table below:
Type
Tightening torque
Size
Fig. 10
Fitting the work load to clamping cylinder
type DNCKE-... .
Fasten the work load to the piston rod.
S
The spanner flat aJ on the piston rod
serves as a counterforce for the locking
nut.
24
With swivel fastening type SNC-...
DNCKE-40-... DNCKE-63-...
5 Nm 8 Nm
M6 M8
DNCKE-...
Fig. 11
Festo DNCKE-.../KEC-... 0204NH English
DNCKE-100-...
10 Nm
M10
aJ