Safety Warnings For Screwdrivers - Bosch GO Professional Manual Original

20 | English
Under abusive conditions, liquid may be ejected from the battery; avoid contact.
u
If contact accidentally occurs, flush with water. If liquid contacts eyes, addition-
ally seek medical help. Liquid ejected from the battery may cause irritation or burns.
Do not use a battery pack or tool that is damaged or modified. Damaged or modi-
u
fied batteries may exhibit unpredictable behaviour resulting in fire, explosion or risk
of injury.
Do not expose a battery pack or tool to fire or excessive temperature. Exposure
u
to fire or temperature above 130°C may cause explosion.
Follow all charging instructions and do not charge the battery pack or tool out-
u
side the temperature range specified in the instructions. Charging improperly or
at temperatures outside the specified range may damage the battery and increase the
risk of fire.
Service
Have your power tool serviced by a qualified repair person using only identical
u
replacement parts. This will ensure that the safety of the power tool is maintained.
Never service damaged battery packs. Service of battery packs should only be per-
u
formed by the manufacturer or authorized service providers.

Safety Warnings for Screwdrivers

Hold the power tool by insulated gripping surfaces, when performing an opera-
u
tion where the fastener may contact hidden wiring. Fasteners contacting a "live"
wire may make exposed metal parts of the power tool "live" and could give the oper-
ator an electric shock.
Use suitable detectors to determine if there are hidden supply lines or contact
u
the local utility company for assistance. Contact with electric cables can cause fire
and electric shock. Damaging gas lines can lead to explosion. Breaking water pipes
causes property damage.
Hold the power tool securely. When tightening and loosening screws be prepared
u
for temporarily high torque reactions.
Before any work on the power tool (e.g. maintenance, tool change, etc.) as well
u
as during transport and storage, set the rotational direction switch to the middle
position. There is risk of injury from unintentionally pressing the on/off switch.
Secure the workpiece. A workpiece clamped with clamping devices or in a vice is
u
held more secure than by hand.
Always wait until the power tool has come to a complete stop before placing it
u
down. The application tool can jam and cause you to lose control of the power tool.
1 609 92A 6M4 | (21.05.2021) Bosch Power Tools