Searching for a track by
listening to track passages
— ZAPPIN™
While playing short track passages from a USB
device in sequence, you can search for a track
you want to listen to.
This function is convenient, for example, when
searching for a track in shuffle or shuffle repeat
mode.
1
During audio playback, touch "ZAP."
Playback starts from a passage of the next
track. You can select the playback time
(page 46), but cannot select the track passage
to play.
"ZAP"
The playback section of each
touched.
track in ZAPPIN mode.
2
Touch "ZAP" when a track you want to
listen to is played.
The track that you select returns to normal
play mode from the beginning.
To search for a track via ZAPPIN mode
again, repeat steps 1 and 2.
In the case of "SensMe™ channels"
or "SensMe™ mood" playback
If you enter ZAPPIN mode during "SensMe™
channels" or "SensMe™ mood" playback, the
most melodic or rhythmical sections* of tracks
are played. For details on the SensMe™
function, see "Enjoying music according to your
mood — SensMe™" on page 26.
* May not be detected correctly.
Tip
The ZAPPIN function is also available during iPod
playback.
30
iPod Operations
For details on the compatibility of your iPod, see
"About iPod" on page 56 or visit the support site
on the back cover.
In these Operating Instructions, "iPod" is used as
a general reference for the iPod functions on the
iPod and iPhone, unless otherwise specified by
the text or illustrations.
Playing an iPod
1
Reduce the volume on this unit.
2
Remove the cap from the USB
connector, and connect the iPod to the
USB connector.
Use of the optional USB connection cable
RC-202IPV is recommended.*
While the iPod is connected, a device
connected to the front AUX terminal becomes
unavailable, and "Front AUX" cannot be
selected when changing the source.
The following display appears on the iPod
screen*
2
, then playback starts from the item
last played.
If an iPod is already connected, to start
playback, touch "Source List," then "iPod/
USB."
*1 To play videos from an iPod with video, use of
the RC-202IPV is required.
*2 May not appear in the case of an iPod touch or
iPhone being connected, or when the iPod was
last played using Passenger App Control.
3
Adjust the volume on this unit.
1