Crown CT38112 Manual Original página 16

Symbol
Intended use of the air tool
The air tool is designed to tighten and unscrew thread-
ed fasteners (bolts, nuts, screws, wood screws, etc.).
Meaning
Width across flat of the nut
to be unscrewed�
Read all safety regulations
and instructions�
Wear safety goggles�
Wear ear protectors�
Wear a dust mask.
Wear protective gloves�
Movement direction�
Rotation direction�
Locked.
Unlocked.
Attention. Important.
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards.
Useful information�
Do not dispose of the air
tool in a domestic waste
container�
Elements of the air tool
1 Tool holder
2 Additional handle *
3 Combination switch (reverse and torque)
4 Threaded plug
5 On / off switch
6 Inlet connector
7 Plug *
8 Oiler *
9 Quick-removable connector *
10 Allen key *
11 Socket wrench *
12 Extension rod *
13 Bolt for additional handle fastening *
14 Output hole
15 Oil-fill hole
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery
Installation / regulation
Before execution of any procedures, disconnect
air tool from compressor.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Mounting / dismounting / setting-up of
some elements is the same for all air
tools models, in this case specific mod-
els are not indicated in the illustration.
Installing / removing the socket wrench (see fig. 1.1)
• When mounting, install socket wrench 11 onto the
tool holder 1, as shown in figure 1.1.
• Disassembly operations do in reverse sequence.
Installing / removing the extension rod (see fig. 1.2)
[CT38113, CT38115]
• When mounting, install extension rod 12 onto the
tool holder 1, as shown in figure 1.2.
• Disassembly operations do in reverse sequence.
Installing / removing the additional handle (see
fig. 2)
[CT38085, CT38116, CT38083, CT38084]
• When mounting, install additional handle 2 and
screw in bolts 13 with the help of Allen key 10, as
shown in figure 2.
• Disassembly operations do in reverse sequence.
Connecting to the compressor (see fig. 3-4)
Note: make sure that the air pressure is
not less than that one specified in the
table "Air tool specification", otherwise
the air tool will work with less efficiency.
English
16