Publicidad
Idiomas disponibles
Idiomas disponibles
(3) Peel off the paper or the sheet that is glued to the roll paper.
Note:
Since the glued portion of the paper should not be printed on, remove one turn (approximately 40 cm) of the
Roll paper from the beginning so that none of the remaining paper has glue on it.
Any adhesive or other material remaining from the glue may adhere to the thermal head and cause a problem,
such as voids on printouts. Therefore, do not forget to remove the glued portion of the paper.
(4) Set the roll paper as shown in the figure, and pull the edge of the paper toward the front of the printer.
Note 1:
Set Roll Paper, pull out the paper from the front side of Printer, and close Top cover (Fig.a)
Note 2:
Setting roll paper such as shown in the figure below may cause a paper jam, uneven printing, or other
printing problems. (Fig.b,c)
Note 3:
The roll paper must have no deformities. Using roll paper such as shown in the figure (Fig.d) below may
cause a paper jam, uneven printing, or other printing problems.
Note 4:
If the loaded roll paper is loose (slack) as shown in the figure (Fig.e) tight up the slack before printing on the
paper. Printing on roll paper that is loose may cause a paper jam, uneven printing, or other printing
problems. Also, it will prevent the printer from detecting paper near end conditions.
(5) Place the paper in the correct orientation, and carefully close the top cover.
Note 1 :
Place the paper in the correct orientation. If the top cover is closed while the paper is not correctly in place, a
paper jam or misaligned printing may occur.
Note 2:
When closing the top cover, press it down on around its center (the location pointed at in the figure below) until
you hear the lock click sound. If the cover is not completely locked, printing does not start.
Top cover
Release lever
Press
here
Now You are ready to print.
*Depending on Printer specification.
Publicidad
